Evaluation and improvement of wastewater treatment plant performance using BioWin

Oloche James Oleyiblo; Jiashun Cao; Qian Feng; Gan Wang; Zhaoxia Xue; Fang Fang

doi:10.1007/s00343-015-4108-8

Your Location：

Home >

Browse articles >

Evaluation and improvement of wastewater treatment plant performance using BioWin

OriginalPaper | Updated：2023-05-16

- Evaluation and improvement of wastewater treatment plant performance using BioWin
- Evaluation and improvement of wastewater treatment plant performance using BioWin
- 海洋湖沼学报（英文） 2015年33卷第2期页码：468-476
- Affiliations：
  
  1. College of Environment Hohai University
  2. National Engineering Research Center of Water Resource Efficient Utilization and Engineering Safety Hohai University
  3. Anhui Guozhen Environmental Protection Sci. and Tech. Co. Ltd.
- Author bio：
- Funds：
  
  Supported by the College of Scientific Innovation Significant Cultivation Fund Financing Projects (No. 708047) and the Key Special Program for Pollution Control (No. 2012ZX07101-003)
- DOI：10.1007/s00343-015-4108-8
  中图分类号：
- 网络首发：2014-10-27，
  
  纸质出版：2015
- Accepted：
Scan QR Code
Evaluation and improvement of wastewater treatment plant performance using BioWin[J]. 海洋湖沼学报（英文）, 2015,33(2):468-476.

Oleyiblo, O.J., Cao, J., Feng, Q. et al. Evaluation and improvement of wastewater treatment plant performance using BioWin., Chin. J. Ocean. Limnol. 33, 468–476 (2015). https://doi.org/10.1007/s00343-015-4108-8
Evaluation and improvement of wastewater treatment plant performance using BioWin[J]. 海洋湖沼学报（英文）, 2015,33(2):468-476. DOI： 10.1007/s00343-015-4108-8.

Oleyiblo, O.J., Cao, J., Feng, Q. et al. Evaluation and improvement of wastewater treatment plant performance using BioWin., Chin. J. Ocean. Limnol. 33, 468–476 (2015). https://doi.org/10.1007/s00343-015-4108-8 DOI：

摘要

Abstract

In this study

the activated sludge model implemented in the BioWin® software was validated against full-scale wastewater treatment plant data. Only two stoichiometric parameters (Y p/acetic and the heterotrophic yield (Y H)) required calibration. The value 0.42 was used for Y p/acetic in this study

while the default value of the BioWin® software is 0.49

making it comparable with the default values of the corresponding parameter (yield of phosphorus release to substrate uptake $(Y_{PO_4 } )$ ) used in ASM2

ASM2d

and ASM3P

respectively. Three scenarios were evaluated to improve the performance of the wastewater treatment plant

the possibility of wasting sludge from either the aeration tank or the secondary clarifier

the construction of a new oxidation ditch

and the construction of an equalization tank. The results suggest that construction of a new oxidation ditch or an equalization tank for the wastewater treatment plant is not necessary. However

sludge should be wasted from the aeration tank during wet weather to reduce the solids loading of the clarifiers and avoid effluent violations. Therefore

it is recommended that the design of wastewater treatment plants (WWTPs) should include flexibility to operate the plants in various modes. This is helpful in selection of the appropriate operating mode when necessary

resulting in substantial reductions in operating costs.

关键词

Keywords

references

APHA. 1998. Standard Methods for the Examination of Water and Wastewater, 20th edn, American Public Health, Washington DC, USA.

Barker P S, Dold P L. 1997. General model for biological nutrients removal activated-sludge systems: model presentation. Water Environ. Res., 69(5): 969–984, http://dx.doi.org/10.2175/106143097X125669.

EnviroSim Associates Ltd. 2008. User Manual for BioWin v.3.0, EnviroSim Associates Ltd., Hamilton, Canada.

Ferrer J, Seco A, Serralta J, Ribes J, Manga J, Asensi E, Morenilla J J, Llavador F. 2008. DESASS: a software tool for designing, simulating and optimising WWTPs. Environ Modell Softw., 23(1): 19–26, http://dx.doi.org/10.1016/j.envsoft.2007.04.005.

Gernaey K V, Loosdrecht M C M, Henze M, Lind M, Jorgensen S B. 2004. Activated sludge wastewater treatment plant modelling and simulation: state of the art. Environ. Modell. Softw., 19(9): 763–783, http://dx.doi.org/10.1016/j.envsoft.2003.03.005.

Henze M, Guje W, Mino T, Matsuo T, Loosdrech M V. 2002. Activated sludge models ASM1, ASM2, ASM2d and ASM3. IWA Scientific and Technical Report No.9, London, UK. p.45–102.

Hulsbeek J J W, Kruit J, Roeleveld P J, van Loosdrecht M C M. 2002. A practical protocol for dynamic modelling of activated sludge systems. Water Sci. Technol., 45(6): 127–136.

Langergraber G, Rieger L, Winkler S, Alex J, Wiese J, Owerdieck C, Ahnert A, Simon J, Maurer M. 2004. A guideline for simulation studies of wastewater treatment plants. Water Sci. Technol., 50(7): 131–138.

Liwarska-Bizukojc E, Biernacki R. 2010. Identification of the most sensitive parameters in the activated sludge model implemented in BioWin software. Bioresour. Technol., 101(19): 7 278–7 285, http://dx.doi.org/10.1016/j.biortech.2010.04.065.

Liwarska-Bizukojc E, Olejnik D, Biernacki R, Ledakowicz S. 2013. Improving the operation of a full-scale wastewater treatment Plant with use of a complex activated sludge model. Environ. Prot. Eng., 39: 659–670, http://dx.doi.org/10.5277/EPE130114.

Mamais D, Jenkins D, Pitt P. 1993. A rapid physical-chemical method for the determination for readily biodegradable soluble COD in municipal Wastewater. Water Res., 27(1): 195–197, http://dx.doi.org/10.1016/0043-1354(93)90211-y.

Meijer S C F, van der Spoel H, Susanti S, Heijnen J J, van Loosdrecht M C M. 2002. Error diagnostics and data reconciliation for activated sludge modelling using mass balances. Water Sci. and Technol., 45(6): 145–156.

Meijer SCF, van Loosdrecht MCM, Heijnen J J. 2001. Metabolic modelling of full-scale biological nitrogen and phosphorus removing WWTP’s. Water Res., 35(11): 2 711–2 723, http://dx.doi.org/10.1016/S0043-1354(00)00567-4.

Melcer H, Dold P L, Jones R M, Bye C M, Takacs I, Stensel H D, Wilson A W, Sun P, Bury S. 2003. Methods for wastewater characterization in activated sludge modelling. Report No. 99-WWF-3 Water Environment Research Foundation (WERF), Alexandria, VA. USA.

Petersen B, Gernaey K V, Henze M, Vanrolleghem P A. 2002. Evaluation of an ASM1 model calibration procedure on a municipal-industrial wastewater treatment Plant. J. Hydroinform., 4: 15–38.

Puig S, van Loosdrecht M C M, Colprim J, Meijer S C F. 2008. Data evaluation of full-scale wastewater treatment plants by mass balance. Water Res., 42(18): 4 645–4 655, http://dx.doi.org/10.1016/j.watres.2008.08.009.

Rieger L, Vanrolleghem P A, Takács I, Johnson B R. 2008. Wastewater Treatment Modelling, Quo Vadis? Water 21, IWA Publishing, London, UK. p.59–60.

Rieger L, Koch G, Kuhni M, Gujer W, Siegrist H. 2001. The EAWAG BIO-P Module for activated sludge model No.3. Water Res., 35(16): 3 887–3 903.

Russel B M, Henriksen J P, Jorgensen S B, Gani R. 2002. Integration of design and control through model analysis. Comput. Chem. Eng., 26(2): 213–225, http://dx.doi.org/10.1016/S0098-1354(01)00742-6.

Sin G, De Pauw D J W, Weijers S, Vanrolleghem P A. 2008. An efficient approach to automate the manual trial and error calibration of activated sludge models. Biotechnol. Bioeng., 100(3): 516–528, http://dx.doi.org/10.1002/bit.21769.

STOWA. 1996. Methods for influent characterization: inventory and guidelines. Report STOWA 96-08. Utrecht, The Netherlands. (in Dutch)

Thomann M. 2008. Quality evaluation methods for wastewater treatment plant data. Water Sci. Technol., 57(10): 1 601–1 609, http://dx.doi.org/10.2166/wst.2008.151.

Vanrolleghem P A. 2001. Model Simulation for Improved Operation and Control of Wastewater Treatment Plants. BIOMATH. Department for Applied Mathematics, Biometrics and Process Control Ghent University, Coupure Links 653, B-9000 Gent, Belgium. http://biomath.rug.ac.be/~peter.

Water Environment Federation (WEF). 2010. Nutrient Removal—A Manual of Practice No. 34, McGraw-Hill, New York, Water Environment Federation, Alexandra, VA22314-1994 USA.

浏览量

Downloads

CSCD

文章被引用时，请邮件提醒。

Submit

工具集

关联资源

Fate of microplastics in urban wastewater treatment plants and their contribution to the receiving river via effluent discharge

Achieving low effluent NO3-N and TN concentrations in low influent chemical oxygen demand (COD) to total Kjeldahl nitrogen (TKN) ratio without using external carbon source

导流锥结构参数对燃气弹射筒内压力冲击平滑效果影响研究

基于最大似然估计的点火概率曲线计算模型取点方法

大涵道比风扇/增压级进气畸变数值模拟研究